Optical OEO Reapeater: PDH, ATM, SDH, GE, STM-1/4/16, OC-3/12/48
Optical OEO Reapeater: PDH, ATM, SDH, GE, STM-1/4/16, OC-3/12/48 PON Extenders / Repeaters FTTX Access AD-Net Selangor, Malaysia, Kuala Lumpur (KL), Petaling Jaya (PJ) Supplier, Suppliers, Supply, Supplies | Catacomm Corporation Sdn Bhd
Quantity

Description

AN-OEO-2S optical repeat/amplification deviceapplied in optical repeat prolongation and OEO amplification for transmission equipments. So far the transmission distance of optical access equipments on LAN and access layer is generally short, single mode equipments can hardly go beyond 100km, multimode equipments go even shorter distance, no more than 5km normally. The equipment is requested to solve the solution for fiber optic transmission distance exceed of the equipment transmitting range ability . It can replace expensive optical power amplifier used on network. The increase of transmission distance can be fulfilled through mode of relay. The network can be deployed and business can be open rapidly and conveniently through the equipment. It is equipped with low cost, low power dissipation and small volume. It is the low cost and high performance transmission solution.

Features

  • A low access optical powerconfigure output optical power at will access rate can be from 0—2.5G up to 2.5Gb/s.
  • AN-OEO-2S supports up to 1 channel bidirection or 2 channel unidirection
  • Support Hot Plug.
  • Support software update.
  • Input&OutputSingle & multi-mode ,WDMMulti-wavelength is optional
  • Single fiber &dual fiber mode is optional.
  • Maximum transmission distance of data signal is around 120 km.
  • Accessible to PDHATMPOSGESTM-1/4/16OC-3/12/48.

Specifications

Technical parameter
Property
Description
Input Wavelength
Optional(850nm/1310nm/1550nm)
Output Wavelength
Optional(850nm/1310nm/1550nm)
Output Power Input Sensitivity
Upon hot-swap SFP module

System parameter

System parameter
Description
Wavelength Range
comply with ITU-T standard
Input Type
PDH
10M/100M/1000M Ethernet
STM-16/STM-4/STM-1
OC-48/OC-12/OC-3
64Kb/s–1.25 or 2.5G 2.5Gb/s Adaptive SFP interface
Input interface
Single modemulti-mode LC/PC
Output interface
Single modemulti-mode LC/PC
Application
        carrier-class /technical grade
Operation Environment
temperature
0-50 /-40 to 85
humidity
      5% to 85%no condensation
Power Supply
   AC 220V50hz
Panel symbol description
Symbol
Description
POWER
Power Button
T
Client Interface LC/PCSFP Optical
Transmitter Interface
R
Client Interface LC/PCSFP Optical Receiver
Back Panel CONSOLE RS232
RS232 Network Management Serial Port
Cable connection
Optical cable/electric cable/wire jumper connection description
wire interface
Quantity
Description
Front Panel T  R
Grey1 or 2
LC/PCSFP optical transceiver port
Back Panel
CONSOLE RS232
1
RS232 Network Management Network Management Serial Port 
Parallel Serial Port Line Connection
Back Panel 220V AC
1
Connect 220V AC power supply
Notes
Optical ports of the equipment are all LC / PC port, please use the corresponding fiber-optic connections. The definition of all the optical ports are left to send, that is, “T”. Please be careful with the optical power may be greater than-5dbm, escape the direct human eye contact, so as to avoid harm.”R” shows receive which indicates the transmission  from the external light source or wire jumper to the devices. Please note that receiving SFP optical power should be less than-3dbm, such as beyond the scope of optical attenuator, connect the equipment to meet the range, in order to avoid equipment damage.

Ordering Information

AN-OEO-2S
Optical repeat/amplification device, with 2 standard SFP slots for SFP modules, AC or DC power as ordering options.

Please leave your enquiry here, we will reply as soon as possible.


*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version