16 E1 modular type Framed/Unframed, FXS/FXO/EM2-4/V35/V.24/RS232/422/385 TDM over IP multiplexer
16 E1 modular type Framed/Unframed, FXS/FXO/EM2-4/V35/V.24/RS232/422/385 TDM over IP multiplexer TDM Over IP Equipment Series Interface Converters AD-Net Selangor, Malaysia, Kuala Lumpur (KL), Petaling Jaya (PJ) Supplier, Suppliers, Supply, Supplies | Catacomm Corporation Sdn Bhd
Quantity

Description


The AN-TDM-IP-16E1-MOD device is mainly used to provide 4 service card slots on the IP network. It can be inserted into the E1 module (4 E1 interfaces), voice module (4/8/16 FOX/FXS interface), V.35 module (2 channels). V.35 interface), serial interface module (4-ch RS232/422/485 interface); maximum capacity can be filled in 4 slots. Enables operators and enterprises to seamlessly and reliably connect TDM devices and user Ethernet on a standard low-cost wireless or wired Ethernet/IP fabric with no impact on voice quality. TDM over IP is transparent to TDM signals, ensuring that any device with a physical E1 interface is seamlessly connected, such as PBX, mobile base stations, SS7 signaling devices and voice mail systems. Can be used in IP-based communication systems such as LAN, WAN, MAN, and wireless networks.
 
It is with 4 slot for 4*E1 service card, two 100M Ethernet ports, one 100M Ethernet optical port, and one console management interface.
 

Features

  • Provide Console (CLI) and WEB management.
  • Provides 4 slot of 4*E1, 2*100M Ethernet ports, and 1*100M Ethernet SFP port.
  • E1 port can be 75Ω or 120Ω.
  • Transparent transmission of unframed/framing E1 (N*64K) signals over IP networks, in compliance with G.703 regulations.
  • The clock recovery adopts the unique clock algorithm technology, the frequency reproduction is stable, the jitter and drift are small, and the jitter and drift of the recovered clock are in accordance with G.823/G.824 and G.8261.
  • High transmission efficiency, low transmission delay; Ethernet packet length can be set, support long packet; support VLAN setting.
  • Support package loss indicator function for E1 transmission line.
  • Local and remote E1 loop and local E1 enable function.
  • High efficiency transmission, up to 90% bandwidth utility ratio.
  • Support WEB network management for online upgrade of local and remote device software and hardware.
  • Provide 4 slots plug-in modules£º
    • 4×unFramed E1 module£¨75Ω£©/£¨120Ω).
    • 4×Framed E1 module£¨75Ω£©/£¨120Ω£©,any timesolts can be set.
    • 4×FXO/FXS/EM2-4/Magnet telephone module.
    • 8×FXO/FXS/2 line audio/Magnet telephone module.
    • 16×FXO/FXS/2 line audio/Magnet telephone module.
    • 2×V.35/V.24 (2.048M Fixed speed) module.
    • 2×V.35 (N*64K N=1-32) module.
    • 4×RS232/422/485 module.
 

Specifications

  • E1 interface

Standard:      conform to G.703 standard
Code rate:     2.048Mbit/s±50ppm
Code type:     HDB3       
Impendence: 75Ω£¨unbalance£©/ 120£¨balance£©
Connector: BNC£¨unbalance£©/ RJ45£¨balance£©
Jitter tolerance:  conform to G.742 and G.823  
  • Ethernet interface(10/100M)
Interface rate:                         10/100 Mbps, half/full duplex auto-negotiation
Interface Standard:               Compatible with IEEE 802.3, IEEE 802.1Q (VLAN)
MAC Address Capability:      4096
Connector:                               RJ45, support Auto-MDIX
  • 35 interface 
Interface rate:                        2048Kbps
Interface Standard:               Compatible with V.35 Standard
Connector:                               DB25
Connect Mode:                        DCE
Clock Type:                              G.703 restored clock, Internal clock 
  • FXS Phone Interface
Ring voltage:                           75V
Ring frequency:                     25HZ
Two-line Impedance:            600 Ohm (pick up)
Return loss:                             40 dB
  • FXO Switch Interface
Ring detect voltage:                35V
Ring detection frequency:    17HZ-60HZ
Two-line Impedance:             600 Ohm (pick up)
Return loss:                              40 dB
  • Working environment
Working temperature:           -10°C ~ 50°C
Working Humidity:                5%~95 % (no condensation)
Storage temperature:             -40°C ~ 80°C
Storage Humidity:                  5%~95 % (no condensation)
 
Function
Multi-service  16E1 over IP
Ports
One SFP optic port£¬ two 100M Ethernet ports£¬4 slots
Power
AC220V or DC-48V£¨Power optional£©£¬Support power back up
Dimension
(L×W×H)  485*138*45mm 1U rack
Weight
2.5Kg/pcs

Please leave your enquiry here, we will reply as soon as possible.


*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version